# ATR Technology

RF, microwave and millimeter wave components designed, manufactured and tested in-house from DC to 110 GHz.

Address: NO.1 Lizhuang, Xuedian town, Jiaxian 467000, Henan, China

Telephone: +86-1771-9061-040

Inquiry email delivery is not connected.

## How do I choose between a coaxial attenuator and a flanged termination?

Use a coaxial attenuator when you need a defined loss in a signal path, and a termination when the goal is to absorb power at the end of a line. If average power is above roughly 10 W, check the mounting and heat spreading before choosing the connectorised part.

## Can a single product family cover DC to 110 GHz?

Coverage is band by band. Coaxial parts typically serve the lower bands, while waveguide components take over above 18 GHz where losses in coaxial lines become impractical. Tell us the band and interface and we will confirm which family applies.

## Do you provide measured data with standard catalogue items?

Measured data can be provided on request for most catalogue items. For programs that need lot-by-lot records, state this at the quotation stage so the test plan and data format are agreed in advance.

## Can you build a variant of a catalogue part?

Yes. Common changes include attenuation value, connector type, flange pattern, housing length and plating. Send the drawing or the operating conditions and our engineers will confirm feasibility and the minimum order quantity.

## What information is needed to quote a custom waveguide assembly?

Band or frequency range, average and peak power, interface standard, flange type, allowable envelope, operating temperature and the quantity for the first build. A sketch is helpful but not required to start the review.

## What are typical lead times?

Lead time depends on the family, the quantity and whether the item is a catalogue part or a new design. We confirm the schedule with the quotation rather than quoting a single number for every product.

## How are parts packed for international shipment?

Connectorised parts are packed individually with protective caps; ceramic and thin-film parts use waffle packs or tape and reel as agreed. Export documentation is prepared with the shipment.

## Which parameters are tested before shipment?

Insertion loss, return loss or VSWR, and isolation or coupling where applicable. Power handling and environmental screening are available as additional acceptance steps and are defined with the order.

## Can you support a source inspection or a first-article report?

First-article reports with measured data can be prepared for new designs. Source inspection arrangements are agreed at the quotation stage so the required records and access are clear to both sides.

